Procedure to do the Experiment

1. When the page is loaded user will be presented with a circuit representation of IVG on the right frame.


2. The input parameters namely Charging Voltage(V_O),Ground Capacitance(C_g),Tail Capacitance(C_l),Front Inductance(L_f),Load Inductance(L_l),Front Resistance(R_f),Tail Resistance(R_t),Tail Time required(T_d)are displayed with default values on the other frame.


3. The user can conduct the experiment with the default values,However the parameters can also be changed and the experiment performed.


4. Each of these parameters can be changed by using the -- and + buttons along the text box.


5. The setup Generator button is clicked to display the flash version of Experimental setup of IVG.


6. When the experimental setup is loaded,the Trigger Generator button is clicked to trigger the generator.


7. When the generator is triggered the sphere gaps break-down and the impulse waveform so generated is displayed.


8. The salient features of the waveform and the values of output parameters like Peak Voltage,Front Time and Tail Time are displayed in the form of a graph.


9. The end user is given an option to change the previously set input parameter values and to perform the experiment with a new set of input parameters on the same page without going back to previous page.


10. The user can also compare the graphs generated for different input parameter values.