Capacitative Rectification for Full Wave Rectifier

CIRCUIT

INSTRUCTION

  1. Take 4 diodes, Load resistor of 1KOhms and capacitor of 102μF.
  2. Connect to AC Voltage Source of 50 Hz, 12 V.
  3. Click on 'ON' button to make the circuit on.
  4. Click on 'Sine Wave' button to observe the input waveform.
  5. Click on 'Run Simulation' button to observe the filtered waveform.
  6. Vary the amplitude using the controllers.
  7. Observe the corresponding waveform.
  8. Channel 1 shows the input wave, Channel 2 shows the output wave and Dual shows both the input and output wave.

GRAPH PLOT

Print

CONTROLS

   Vpch1:                   V

   Position Y-Axis:   

   Phase:                    Deg

    Frequency:             Hz

   Vpch2:                    V

   Position Y-Axis:    

    Phase:                 Deg

    Frequency:            

CALCULATION

Calculator

   Measure the \(V_m\)

    \(V_{rms}= \frac{V_m}{√2}\)

    \(V_{dc}= \frac{V_m} {π}\)
    Ripple Factor=\(\frac{V_{ac}}{V_{dc}}\) \(\quad\)Since, \(V_{ac}=\frac{\sqrt(V^2_{rms}-V^2_{dc})}{V_{dc}}\)